Z3 Rear Inner Wing Liner Removal

ZTec

ZTec

Zorg Guru (IV)
Supporter
British Zeds
The M44 Massive
Joined
Oct 18, 2014
Points
171
Location
Llantwit Major
Model of Z
Z3
Hi all, has anyone ever removed the inner wing liner? Any tips gratefully received.:thumbsup:
 
After you remove all the screws etc. pull it away from the end of the sill in a downward direction. Also pull it away from the inside leaving the arch around the wheel arch till last. Hope that makes some sense, and they are a bloody good fit by the way.

Tony.
 
Removed all the screws, but liner would not budge, absolutely solid in place. Will leave it for another day. Telling me they're a bloody good tight fit.:mad:
 
ZTec said:
Removed all the screws, but liner would not budge, absolutely solid in place.........
Click to expand...
They are tight but should not be that bad - start from the front and work along inner edge and that should move and you can then twist it out. A possibility is that a previous owner has undersealed them in - try running a flat blade under the edge to break bond.
 
They are a really tight fit, don't worry about damaging the liner as they are very tough. Get ready to be showered in mud and debris when it does let go ;)
 
Have you removed the two screws under the front edge?
 
Should be four screws in total @ZTec two in the wing and one at the bottom of each side. I found pulling it down from the inner side behind the shock helped dislodge it.

Lee
 
Lee said:
Should be four screws in total @ZTec two in the wing and one at the bottom of each side. I found pulling it down from the inner side behind the shock helped dislodge it.

Lee
Click to expand...
I'll try that.
 
You must log in or register to reply here.
Back
Top